The GTV-CS Castellated In-Line Tile Vent is designed for three main purposes: Roof void ventilation; Mechanical extraction; Soil ventilation, all through a castellated roof covering. The in-line profile design of this vent tile makes it almost invisible when installed at either high or low level, with no unsightly hoods or external ducting on show from the exterior to maintain an unbroken appearance to the roofline.
The GTV-NP Non-Profile In-Line Tile Vent is designed for three main purposes: Roof void ventilation; Mechanical extraction; Soil ventilation, all through a non-profile roof covering. The in-line design of this vent tile makes it almost invisible when installed at either high or low level, with no unsightly hoods or external ducting on show from the exterior to maintain an unbroken appearance to the roofline.
Slide And Lock 10mm / 25mm
Over Fascia Vents Featuring Our Unique Slidelock Technology Enabling Rapid Installation With Secure Continual Ventilation. Our Unobtrusive And Easy To Install Fascia Vents Are Available In Two Sizes; 10mm And 25mm. Allows An Air Stream In To The Roof Void Between The Felt And Fascia Board. Pieces Are 500mm With Interlocking Male And Female Ends To Allow For A Continuous Length.
Telecopic Underfloor Vents Facilitate A Flow Of Air From Beneath Suspended Timber Block And Beam Floors Through The Cavity. The Units Are Adjustable Vertically To Extend Through A Number Of Brick Courses.the Front Of The Vent Is Designed To Fit An Easy-trim Brick Vent Or, Where Horizontal Extension Is Required, And Easy-trim Cavity Sleeve Can Be Used. The Rear Of The Vent Features A Grill Panel Designed To Prevent The Entry Of Insects, Rodents Or Debris So As To Avoid Airflow Blockages.
The GTV-CS Castellated In-Line Tile Vent is designed for three main purposes: Roof void ventilation; Mechanical extraction; Soil ventilation, all through a castellated roof covering. The in-line profile design of this vent tile makes it almost invisible when installed at either high or low level, with no unsightly hoods or external ducting on show from the exterior to maintain an unbroken appearance to the roofline.
The GTV-NP Non-Profile In-Line Tile Vent is designed for three main purposes: Roof void ventilation; Mechanical extraction; Soil ventilation, all through a non-profile roof covering. The in-line design of this vent tile makes it almost invisible when installed at either high or low level, with no unsightly hoods or external ducting on show from the exterior to maintain an unbroken appearance to the roofline.
Slide And Lock 10mm / 25mm
Over Fascia Vents Featuring Our Unique Slidelock Technology Enabling Rapid Installation With Secure Continual Ventilation. Our Unobtrusive And Easy To Install Fascia Vents Are Available In Two Sizes; 10mm And 25mm. Allows An Air Stream In To The Roof Void Between The Felt And Fascia Board. Pieces Are 500mm With Interlocking Male And Female Ends To Allow For A Continuous Length.
Telecopic Underfloor Vents Facilitate A Flow Of Air From Beneath Suspended Timber Block And Beam Floors Through The Cavity. The Units Are Adjustable Vertically To Extend Through A Number Of Brick Courses.the Front Of The Vent Is Designed To Fit An Easy-trim Brick Vent Or, Where Horizontal Extension Is Required, And Easy-trim Cavity Sleeve Can Be Used. The Rear Of The Vent Features A Grill Panel Designed To Prevent The Entry Of Insects, Rodents Or Debris So As To Avoid Airflow Blockages.