Pressed steel outer casing and a cast aluminium pump stand offer increased protection of the stainless steel and rubber base plate
A combination of a rubber pump chamber and a urethane vortex impeller enables the design to offer excellent wear resistance in site water applications that contain sand and silt in suspension, thus maintaining performance and reliability.
Integral swing check valve which will prevent backflow of water from the discharge hose
The LSC1.4S or “puddle sucker†is able to pump water down to 1mm, which makes it suitable for pumping large or small areas of nuisance water found on flat surfaces. It incorporates a dual position outlet port, to enable the user to position the outlet hose horizontally or vertically and avoid it kinking
The BPS series, in thermoplastic, is designed for clean and slightly dirty water. The top discharge design makes them suitable for partial immersion applications and where space or access is restricted
The LSC1.4S or “puddle sucker†is able to pump water down to 1mm, which makes it suitable for pumping large or small areas of nuisance water found on flat surfaces. It incorporates a dual position outlet port, to enable the user to position the outlet hose horizontally or vertically and avoid it kinking
The BPS series, in thermoplastic, is designed for clean and slightly dirty water. The top discharge design makes them suitable for partial immersion applications and where space or access is restricted