Much cheaper than a Dockra but same engineering uses. Dimensions very accurate.
Only 4 stars as around 2 dozen of the bricks had a brown water stain probably from being stored outside without adequate cover.
Sovereign Fleeced Overseal Tape is a synthetic butyl/rubber based preformed strip sealant laminated with a non woven polyester fleece. It's primarily used for creating a joint overseal where SovDrain Cavity Drain Membranes are used.
Size
2mm x 100mm x 10m
Length
10m
Thickness
2mm ± 0.2mm
Width
100mm
Material
Synthetic Butyl/Rubber Sealant Laminated with Non-woven Polyester Fleece
This highly efficient block (thermal conductivity of just 0.11 W/mK) is sufficiently loadbearing for two storey buildings and can be used below DPC. Identified by the distinctive painted blue line, Celcon Solar Grade has a compressive strength of 2.9N/mm2 and is principally used where enhanced thermal performance is required.
Made To Order
N
Manufacturer Model No
URC100100
Brand Name
Celcon
Height
215 mm
Fire Resistance Minutes
Up to 120 minutes (2 hours) for load-bearing applications, and up to 240 minutes (4 hours) for non-load-bearing partitions.
Fleece backed 100 mm waterproof butyl tape gives a well-bonded seal to the mesh face of Drybase. Plaster Membrane. The fleece backing to this tape also accepts a plaster coat finish as well as plaster adhesive where a dot and dab plasterboard system is preferred.
A premium-quality, high-strength clay engineering brick manufactured by Ibstock at the Atlas factory. Combining a minimum compressive strength of 60N/mm2 with low water absorption, this vertically perforated, smooth wirecut red brick is engineered to deliver exceptional structural integrity and frost resistance in the most demanding environments.
Sovereign Fleeced Overseal Tape is a synthetic butyl/rubber based preformed strip sealant laminated with a non woven polyester fleece. It's primarily used for creating a joint overseal where SovDrain Cavity Drain Membranes are used.
This highly efficient block (thermal conductivity of just 0.11 W/mK) is sufficiently loadbearing for two storey buildings and can be used below DPC. Identified by the distinctive painted blue line, Celcon Solar Grade has a compressive strength of 2.9N/mm2 and is principally used where enhanced thermal performance is required.
Fleece backed 100 mm waterproof butyl tape gives a well-bonded seal to the mesh face of Drybase. Plaster Membrane. The fleece backing to this tape also accepts a plaster coat finish as well as plaster adhesive where a dot and dab plasterboard system is preferred.
A premium-quality, high-strength clay engineering brick manufactured by Ibstock at the Atlas factory. Combining a minimum compressive strength of 60N/mm2 with low water absorption, this vertically perforated, smooth wirecut red brick is engineered to deliver exceptional structural integrity and frost resistance in the most demanding environments.